MCS Fan override kit######x3a; Toggle switch with audio - Polaris plug & play. Easy mount toggle switch with rubber weather cover mounts into 1/2 hole.
Unique 3 position switch with ON / OFF / FACTORY setting. Audible alarm sounds if you forget to turn the switch back on.This MCS fan override kit allows you to gain complete control of your electric fan via a 3 positions switch. ON (manually turns on fan to reduce engine temperature).
OFF (disable the fan; great for water or creek crossings). Additionally, we've included a prewired red LED fan indicator light into the harness.
Anytime the fan is on this light will turn on. Simply drill a 3/4 hole to mount the LED or zip tie it within view.
As we all know, entering deep water or mud when your electric fan is running can cause serious damage to the fan and motor rendering it useless. If your fan quits on you 18 miles back into the woods you're in trouble. To combat this problem, many riders opt to install a switch that will disable the fan.This unique kit was designed out of the need for something more. As avid ATV and UTV riders, we didn't want to settle for what everyone seems to have which is a basic switch to turn the fan on or off. How many times have you done that and then forgot to turn the fan back on? The MCS kit has a built in audible alarm that will sound if your switch is in the OFF position and the thermostat kicks on. Once you move the switch to either ON or FACTORY mode, the alarm will stop. Install the MCS fan override kit. RZR, RANGER, SPORTSMAN (will NOT fit RZR TURBO). Commander, Defender, Outlander, Renegade, Maverick. Check plug against diagram to confirm fitment.
NOTE: If the 2 pin connector on your FAN wire has the MALE connector with female pins and has ground in position (A) which is usually a black wire and 12v+ in position (B) which is usually a blue wire, then it should work. (the male connector is the connector with the visible green rubber seal in the pictures) So long as this male connector is the one that you have on the wire attached to your fan then this should be the proper kit. For plug n play operation. Simply plug this T harness into the fan connector, run the wires to the switch and the 12v+ wire to your battery (or ignition source) and you're done. Painfully simple to install and only takes a few minutes in most cases.In no event shall Advance MCS Electronics, Inc. Even if made aware of the possibilty of such damages.
The item "Fan Over ride Kit for Polaris RZR Ranger Can Am Maverick Defender Commander" is in sale since Thursday, November 10, 2016. This item is in the category "eBay Motors\Parts & Accessories\ATV, Side-by-Side & UTV Parts & Accessories\Electrical Components". The seller is "yovus" and is located in Goshen, Indiana. This item can be shipped to United States, Canada.